What is the best/easiest way to cut a slot in a 1/4" Brass rod for an e-clip? The slot needs to be about .020" deep and .030" wide. The dimensions are not that critical - I just want to keep something from falling off a stationary shaft. Two slots will be about 1/4" from the end of the rod. One will be about 3" from the end of the rod.
Dallas Makerspace Show and Tell - June 2017 - Show and Tell - Dallas Makerspace Talk
Userlandia
Are the more premium printers really that 'Set and forget'? : r/3Dprinting
Dallas Makerspace Show and Tell - June 2017 - Show and Tell - Dallas Makerspace Talk
Dallas Makerspace Talk
Dallas Makerspace Show and Tell - March 2017 - Show and Tell - Dallas Makerspace Talk
How do I cut an e-clip slot - Machine Shop - Dallas Makerspace Talk
Show and Tell May 2020 - Show and Tell - Dallas Makerspace Talk
Dallas Makerspace Talk
Dallas Makerspace Show & Tell - December 2018 - #40 by james_hoggatt - Show and Tell - Dallas Makerspace Talk
2014 September Preston Hollow by Advocate Media - Dallas - Issuu
Category:Laser - Dallas Makerspace
Dallas Makerspace Show and Tell - June 2017 - Show and Tell - Dallas Makerspace Talk