Hi Guys, This is my first time to use 7805 to convert 12V to 5V. I have a few questions hope you guys can enlighten me. 🙂 Attached is my 12V to 5V diagram. My question is: Do I need really need to add a diode 1N4007 between 12V and 7805? Is it correct to use 470uf + 0.1uf (input) and 0.1uf + 220uf (output)? (Got this values from ) Can I connect the 5V output to Nano's VIN? Understand that the 7805 got heating issue, is there anyway to reduce the heat? As i will
12v opto isolated circuit - not working - General Electronics - Arduino Forum
Variable voltage (0-12V) using PWM from Arduino - General Electronics - Arduino Forum
swithcing on/off an LM7805 - General Electronics - Arduino Forum
Solved* Voltage Regulators wasting too much power, or Ouch! Dang that's hot! - General Electronics - Arduino Forum
Simple 7805-based 5V regulator for Arduino projects - Share Project - PCBWay
Getting 0-5V with PWM - General Electronics - Arduino Forum
Car Keypad - #39 by system - Exhibition - Arduino Forum
Looking for a voltage regulator that can step down from about 60 volt back to 5v - General Electronics - Arduino Forum
Circuit Power Question - Motors, Mechanics, Power and CNC - Arduino Forum
7805 Voltage Regulator Output Voltage Increasing as Load Increases - General Electronics - Arduino Forum
Appropiate resistor ratings for making a switching regulator with a 7812? - General Electronics - Arduino Forum
Issue with powering ESP32 Dev Module with 5V regulator(7805) from 12V power supply - General Electronics - Arduino Forum
5V Power Supply using 7805 Voltage Regulator with Design